TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1707-05 Proportional Sole-
10. Using digital multimeter (WP
No Continuity - Proceed to step 11.
noid Valve (Left Drive Motor)
0283), test for continuity between
Continuity - Replace chassis harness
Current Below Normal -
pin 29 on chassis harness to plat-
(WP 0153, WP 0154). Ensure all har-
Continued
form harness connector CH-C1
ness connectors are reconnected.
(WP 0018, Figure 81) and all
Verify proper operation of machine
other pins on chassis harness to
(TM 5-2410-240-10).
platform harness connector CH-
C1 (WP 0018, Figure 81).
11. Disconnect platform harness
ECM J1 connector PL-C4 (WP
0018, Figure 217) from machine
ECM (WP 0147, WP 0149).
12. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from machine
ECM (WP 0147, WP 0149).
13. Using digital multimeter (WP
Continuity - Proceed to step 14.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 58 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 29 on plat-
reconnected. Verify proper operation
form harness to chassis harness
of machine (TM 5-2410-240-10).
connector PL-C18 (WP 0018, Fig-
ure 226).
14. Using digital multimeter (WP
Continuity - Proceed to step 15.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 60 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 17 on plat-
reconnected. Verify proper operation
form harness to chassis harness
of machine (TM 5-2410-240-10).
connector PL-C18 (WP 0018, Fig-
ure 226).
15. Using digital multimeter (WP
No Continuity - Proceed to step 16.
0283), test for continuity between
Continuity - Replace platform wiring
pin 58 on platform harness ECM
harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and all other pins on
reconnected. Verify proper operation
platform harness ECM J1 connec-
of machine (TM 5-2410-240-10).
tor PL-C4 (WP 0018, Figure 217).
0020-119
