TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1707-05 Proportional Sole-
16. Using digital multimeter (WP
No Continuity - Replace machine
noid Valve (Left Drive Motor)
0283), test for continuity between
ECM (WP 0147, WP 0149). Ensure all
Current Below Normal -
pin 58 on platform harness ECM
harness connectors are reconnected.
Continued
J1 connector PL-C4 (WP 0018,
Verify proper operation of machine
Figure 217) and all other pins on
(TM 5-2410-240-10).
platform harness ECM J2 connec-
Continuity - Replace platform wiring
tor PL-C5 (WP 0018, Figure 218).
harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
1707-06 Proportional Sole-
noid Valve (Left Drive Motor)
Always inspect harness connectors that are involved in circuit. Poor
Current Above Normal
connections can often be cause of an electrical circuit problem. Verify
that all connections in circuit are clean, secure, and connections are in
good condition. If a problem with connection is found, correct problem
and verify diagnostic code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
1707-06 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect pump harness LH
drive motor solenoid connector
CH-C8 (WP 0018, Figure 87) from
LH drive motor solenoid.
4. Check for diagnostic codes (WP
1707-06 Code Active - Proceed to
step 5.
1707-05 Code Active - Replace LH
drive motor solenoid (WP 0128).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
5. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
6. Disconnect chassis harness to
platform harness connector CH-
C1 (WP 0018, Figure 81) from
platform harness to chassis har-
ness connector PL-C18 (WP
0018, Figure 226).