TM 5-2410-240-23-1
0021
Table 1. Cab Troubleshooting Without Codes. - Continued.
0021
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
6. Front Flood Lamp(s) Will Not
Test Step 16. Test 608-GN Flood
Work - Continued
Lamp Relay #1 Output Circuit
and 200-BK Ground Circuit
Inside Front Flood Lamp for
High Resistance or Open.
N OT E
This test applies to all D6K Dozer front flood lamps. Repeat test
steps to test each flood lamp as required.
1. Disassemble flood lamp (WP
0256).
2. Using digital multimeter, mea-
Resistance Less Than 0.3 Ohms
sure resistance (WP 0283)
- Proceed to step 3.
between flood lamp terminal 1
Resistance 0.3 Ohms or Greater
and bulb terminal 1
- Replace flood lamp (WP 0256).
(Figure 42).
Connect HL-C1 (WP 0018, Figure
175) on C-C101 (WP 0018, Figure
46) (WP 0229).
Connect C-C30 (WP 0018, Figure
27) on flood lamp relay #1 (WP
0018, Figure 54).
For D6K Dozer with Ripper, install
ripper operation control handle
(WP 0218). For D6K Dozer with
Winch, install winch operation
control handle (WP 0217).
Verify proper operation of flood
lamps (TM 5-2410-240-10).
0021-117