TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0298-03 Brake Pedal Position Switch
7. Using digital multimeter, test
No Continuity - Replace lower
Voltage Above Normal - Continued
for continuity (WP 0283)
cab harness (WP 0228). Ensure all
between harness connector
harness connectors are recon-
C-C47 (WP 0018, Figure 35)
nected. Verify proper operation of
terminal 3 and harness con-
machine (TM 5-2410-240-10).
nector C-C12 (WP 0018,
Continuity - Proceed to step 8.
Figure 22) terminal 36.
8. Disconnect harness connec-
tor PL-C5 (WP 0018, Figure
218) from equipment ECM J2.
9. Using digital multimeter, test
No Continuity - Replace platform
for continuity (WP 0283)
harness (WP 0150, WP 0155).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 28 and harness con-
tion of machine (TM 5-2410-240-
nector PL-C1
10).
(WP 0018, Figure 214) termi-
Continuity - Proceed to step 10.
nal 37.
10. Using digital multimeter, test
No Continuity - Replace platform
for continuity (WP 0283)
harness (WP 0150, WP 0155).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 23 and harness con-
tion of machine (TM 5-2410-240-
nector PL-C1 (WP 0018,
10).
Figure 214) terminal 36.
Continuity - Replace machine
ECM, (WP 0147, WP 0149).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
0298-04 Brake Pedal Position Switch
Voltage Below Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in the circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).