TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0298-04 Brake Pedal Position Switch
14. Using digital multimeter, test
No Continuity - Machine ECM
Voltage Below Normal Continued
for continuity (WP 0283)
faulty. Replace machine ECM
between PL-C5 (WP 0018,
(WP 0147, WP 0149). Ensure all
Figure 218) equipment ECM
harness connectors are recon-
J1 terminal 23 and all other
nected. Verify proper operation of
terminals in harness connec-
machine (TM 5-2410-240-10).
tor PL-C5 (WP 0018, Figure
Continuity - Replace platform har-
218).
ness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
0490-03 Hydraulic Lockout Switch
Voltage Above Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor C-C2 (WP 0018, Figure 14)
from implement lockout switch
(WP 0018, Figure 62). Refer
to Right Side Console in Cab
Trim Replacement
(WP 0212).