TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1700-03 Joystick Position Sensor
(Left/Right) Voltage Above Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C5 (WP 0018,
Figure 71) from transmission
control handle base.
4. Turn battery disconnect switch
and ignition switch to ON posi-
tion (TM 5-2410-240-10).
5. Using digital multimeter (WP
Voltage Less Than Specified
0283), measure 10-volt supply
Range - Proceed to step 7.
circuit between harness con-
Voltage Within Specified Range
nector CA-C5 (WP 0018, Fig-
- Proceed to step 6.
ure 71) terminal 1 and 2.
There should be approximately
10 volts 0.5 volts.
6. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 7.
between harness connector
Voltage Within Specified Range -
CA-C5 (WP 0018, Figure 71)
Replace left joystick control
terminal 2 and 6.
(WP 0239). Ensure all harness
There should be approximately
connectors are reconnected. Verify
5 volts 0.5 volts.
proper operation of machine (TM
5-2410-240-10).
7. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
8. Disconnect harness connec-
tor CA-C1 (WP 0018, Figure
69) from harness connector C-
C24 (WP 0018, Figure 26).
