TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1700-03 Joystick Position Sensor
23. Using digital multimeter, test
No Continuity - Replace machine
(Left/Right) Voltage Above Normal -
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
Continued
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 25 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform har-
ness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
1700-04 Joystick Position Sensor
(Left/Right) Voltage Below Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C5 (WP 0018, Figure
71) from transmission control
handle base.
4. Turn battery disconnect switch
and ignition switch to ON posi-
tion (TM 5-2410-240-10).