TM 5-2410-240-23-1
0022
Table 1. Window Wiper and Washer Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Front Windshield Wiper
12. Using digital multimeter, test for
No Continuity - Proceed to step 13.
Does Not Operate Prop-
continuity (WP 0283) between
Continuity - Replace lower cab wiring
erly Continued
front windshield wiper switch har-
harness (WP 0228). Ensure all har-
ness connector C-C5 (WP 0018,
ness connectors are reconnected.
Figure 17) terminal 6 and cab
Install a new #26 15A fuse (TM 5-
ground.
2410-240-10). Verify proper operation
of machine (TM 5-2410-240-10).
13. Disconnect harness connector C-
C40 (WP 0018, Figure 30) from
harness connector FP-C5 (WP
0018, Figure 170).
14. Using digital multimeter, test for
No Continuity - Proceed to step 15.
continuity (WP 0283) between
Continuity - Replace lower cab wiring
front windshield wiper switch har-
harness (WP 0228). Ensure all har-
ness connector C-C5 (WP 0018,
ness connectors are reconnected.
Figure 17) terminal 5 and cab
Install a new #26 15A fuse (TM 5-
ground.
2410-240-10). Verify proper operation
of machine (TM 5-2410-240-10).
15. Using digital multimeter, test for
No Continuity - Proceed to step 16.
continuity (WP 0283) between
Continuity - Replace lower cab wiring
front windshield wiper switch har-
harness (WP 0228). Ensure all har-
ness connector C-C5 (WP 0018,
ness connectors are reconnected.
Figure 17) terminal 5 and all other
Install a new #26 15A fuse (TM 5-
terminals in connector C-C5 (WP
2410-240-10). Verify proper operation
0018, Figure 17).
of machine (TM 5-2410-240-10).
16. Remove fuse #26 (TM 5-2410-
240-10).
17. Using digital multimeter, test for
No Continuity - Replace front wind-
continuity (WP 0283) between
shield wiper/washer switch (WP
harness connector FP-C5 (WP
0212). Ensure all harness connectors
0018, Figure 170) terminal 11 and
are reconnected. Install a new #26
cab ground.
15A fuse (TM 5-2410-240-10). Verify
proper operation of machine (TM 5-
2410-240-10).
Continuity - Replace fuse panel
harness (WP 0201). Ensure all
harness connectors are reconnected.
Install a new #26 15A fuse (TM 5-
2410-240-10). Verify proper operation
of machine (TM 5-2410-240-10).
