TM 5-2410-240-23-1
0023
Table 1. Blade, Winch, and Ripper Troubleshooting Without Codes - Continued.
0023
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Temperature of Hydrau-
4. Connect MSD (WP 0016). Select
Code Active - Diagnose and repair
lic Oil Is Too Hot - Con-
machine control D6K ECM and
active code (WP 0013).
tinued
check for active diagnostic and
Code Not Active - Operate and cycle
event codes.
all hydraulic systems components
through full range several times.
Return machine to service.
2. Any Implement Moves
WARN I N G
When Control Lever Is in
HOLD Position
DO NOT disconnect or remove any hydraulic system hoses, tubes, or
fittings unless engine is shut down and hydraulic system pressure has
been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool
before removing any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performance of maintenance can be
very slippery. Immediately wipe up any spills.
Use extreme caution when handling heavy parts. Provide adequate
support and use assistance during procedure.
Failure to follow these wanings may result in injury or death to person-
r
nel.
C AU T I O N
Wipe area clean around hydraulic system, and cap all hydraulic hose
ends along with component connections during removal to protect
against contamination. Failure to follow this caution may cause damage
to equipment.
1. Inspect hydraulic system for
Hydraulic System Leaking or Dam-
Class III leak and damage.
aged - Repair as necessary.
Hydraulic lines must be free from
Hydraulic System OK - Proceed to
kinks, sharp bends, and restric-
step 2.
tions.
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Code Active - Diagnose and repair
2. Connect MSD (WP 0016). Select
active code (WP 0013).
machine control D6K ECM and
check for active diagnostic and
Code Not Active - Proceed to step 3.
event codes.
