TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0498-05 Blade Tilt Left Sole-
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
noid Current Below Normal -
0283), measure resistance
Proceed to Test Step 4.
Continued
between PL-C4 terminal 62 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 217) and PL-C18
Replace platform wiring harness: with
terminal 9 (WP 0018, Figure 226).
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 0498-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 0498-05 is not active.
Code 0498-05 Not Active - Trouble-
shooting complete.
0023-47