TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0498-06 Blade Tilt Left Sole-
3. Disconnect platform wiring har-
noid Current Above Normal -
ness connector PL-C5 (WP 0018,
Continued
Figure 218) from ECM J2: with
Ripper (WP 0147); with Winch
(WP 0149).
4. Disconnect platform wiring har-
ness connector PL-C2 (WP 0018,
Figure 215) from equipment ECM
(WP 0148).
5. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 6.
PL-C4 terminal 62 and all other
Continuity on One or More Test
circuits in PL-C4 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 217).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PL-C4 terminal 62 (WP 0018, Fig-
Continuity on One or More Test
ure 217) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness: with Ripper (WP 0150) or with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
0023-51