TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0498-06 Blade Tilt Left Sole-
7. Using digital multimeter (WP
No Continuity on Any Test Points -
noid Current Above Normal -
0283), test for continuity between
Proceed to step 8.
Continued
PL-C4 terminal 62 (WP 0018, Fig-
Continuity on One or More Test
ure 217) and all circuits in PL-C2
Points - Replace platform wiring har-
(WP 0018, Figure 215).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
8. Using digital multimeter (WP
No Continuity on Test Point -
0283), test for continuity between
Replace machine ECM: with Ripper
(WP 0147); with Winch (WP 0149).
PL-C4 terminal 62 (WP 0018, Fig-
ure 217) and ground.
Connect platform wiring harness con-
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
0023-52