TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0498-05 Blade Tilt Left Sole-
Test Step 4. Test H802-GY PMW
noid Current Below Normal -
Driver Return Circuit for High
Continued
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace machine ECM: with Ripper
between PL-C4 terminal 60 (WP
(WP 0147); with Winch (WP 0149).
0018, Figure 217) and PL-C18
Connect platform wiring harness con-
terminal 17 (WP 0018, Figure
nector PL-C18 (WP 0018, Figure 226)
226).
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness: with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C21 on blade tilt left sole-
noid: with Ripper (WP 0018, Figure
94); with Winch (WP 0018, Figure
265).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
2. Using MSD (WP 0016), select
Code 0498-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 0498-05 is not active.
Code 0498-05 Not Active - Trouble-
shooting complete.
0023-48