TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1197-03 Blade Lower Sole-
noid Voltage Above Normal
Always inspect harness connectors thatare involved in the circuit. Poor
connections can often be the cause of an electrical circuit problem. Ver-
ify that all connections in the circuit are clean and secure, and connec-
tions are in good condition. If a problem with a connection is found,
correct problem and verify diagnostic code is active before performing
this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
Test Step 1. Test for Shorted Chas-
sis Wiring Harness.
1. Connect MSD (WP 0016). Select
machine control D6K ECM and
verify 1197-03 is active.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Remove right rear access cover
from machine (WP 0191).
4. Disconnect platform wiring har-
ness connector PL-C18 (WP
0018, Figure 226) from chassis
wiring harness connector CH-C1
(WP 0018, Figure 81): with Ripper
(WP 0150); with Winch (WP
0155).
5. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
6. Check for active code 1197-03 in
Code 1197-03 Remains Active - Pro-
machine control D6K ECM (WP
ceed to Test Step 2.
Code 1197-03 Becomes Inactive -
Replace chassis wiring harness: with
Ripper (WP 0153); with Winch (WP
0154).
Proceed to step 7.
7. Using MSD (WP 0016), select
Code 1197-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1197-03 is not active.
Code 1197-03 Not Active - Trouble-
shooting complete.
