TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1197-06 Blade Lower Sole-
4. Disconnect chassis wiring har-
noid Current Above Normal -
ness connector CH-C19 from
Continued
blade lower solenoid: with Ripper
(WP 0018, Figure 92); with Winch
(WP 0018, Figure 263).
5. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
6. Check for active code 1197-05 or
Code 1197-06 Remains Active - Pro-
1197-06 in machine control D6K
ceed to Test Step 2.
ECM (WP 0016).
Code 1197-06 Becomes Inactive
and 1197-05 Becomes Active -
Replace blade lower solenoid: with
Ripper (WP 0196); with Winch (WP
0197).
Proceed to step 7.
7. Using MSD (WP 0016), select
Code 1197-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1197-06 is not active.
Code 1197-06 Not Active - Trouble-
shooting complete.
Test Step 2. Test for Shorted Chas-
sis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove right rear access cover
from machine (WP 0191).
3. Disconnect platform wiring har-
ness connector PL-C18 (WP
0018, Figure 226) from chassis
wiring harness connector CH-C1
(WP 0018, Figure 81): with Ripper
(WP 0150); with Winch (WP
0155).
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
Code 1197-06 Remains Active - Pro-
5. Check for active code 1197-05 or
ceed to Test Step 3.
1197-06 in machine control D6K
ECM (WP 0016).
Code 1197-06 Becomes Inactive
and 1197-05 Becomes Active -
Replace chassis wiring harness: with
Ripper (WP 0153); with Winch (WP
0154).
Proceed to step 6.
0023-62