TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1197-06 Blade Lower Sole-
8. Using digital multimeter (WP
No Continuity on Test Point -
noid Current Above Normal -
0283), test for continuity between
Replace machine ECM: with Ripper
Continued
PL-C4 terminal 68 (WP 0018, Fig-
(WP 0147); with Winch (WP 0149).
ure 217) and ground.
Connect platform wiring harness con-
nector PL-C2 (WP 0018, Figure 215)
on equipment ECM (WP 0148).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C19 on blade lower sole-
noid: with Ripper (WP 0018, Figure
92); with Winch (WP 0018, Figure
263).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
Continuity on Test Point - Replace
platform wiring harness: with Ripper
(WP 0150); with Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C19 on blade lower sole-
noid: with Ripper (WP 0018, Figure
92); with Winch (WP 0018, Figure
263).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 1197-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1197-06 is not active.
Code 1197-06 Not Active - Trouble-
shooting complete.
0023-65