TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1197-05 Blade Lower Sole-
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
noid Current Below Normal -
0283), measure resistance
Proceed to Test Step 4.
Continued
between PL-C4 terminal 68 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 217) and PL-C18
Replace platform wiring harness: with
terminal 11 (WP 0018, Figure
Ripper (WP 0150); with Winch (WP
226).
0155).
Connect chassis wiring harness con-
nector CH-C19 on blade lower sole-
noid: with Ripper (WP 0018, Figure
92); with Winch (WP 0018, Figure
263).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 1197-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1197-05 is not active.
Code 1197-05 Not Active - Trouble-
shooting complete.
Test Step 4. Test 975-WH PMW
Driver Return Circuit for High
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace machine ECM: with Ripper
between PL-C4 terminal 55 (WP
(WP 0147); with Winch (WP 0149).
0018, Figure 217) and PL-C18
Connect platform wiring harness con-
terminal 21 (WP 0018, Figure
nector PL-C18 (WP 0018, Figure 226)
226).
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C19 on blade lower sole-
noid: with Ripper (WP 0018, Figure
92); with Winch (WP 0018, Figure
263).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
0023-60