TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-03 Winch Spool-Out
4. Disconnect platform wiring har-
Solenoid Voltage Above Nor-
ness connector PL-C4 (WP 0018,
mal - Continued
Figure 217) from ECM J1 (WP
0149).
5. Disconnect pump wiring harness
connector PH-C9 (WP 0018, Fig-
ure 213) from reel-out solenoid
(WP 0267).
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PL-C2 terminal 32 and all other
Continuity on One or More Test
circuits in PL-C2 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 215).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 (WP 0018, Figure 213)
on reel-out solenoid (WP 0267).
Install right side debris guards (WP
0187).
Proceed to step 9.
7. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 8.
PL-C2 terminal 32 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 (WP 0018, Figure 213)
on reel-out solenoid (WP 0267).
Install right side debris guards (WP
0187).
Proceed to step 9.
0023-106