TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-03 Winch Spool Out
8. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Voltage Above Nor-
0283), test for continuity between
Proceed to Test Step 4.
mal - Continued
PL-C2 terminal 32 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 (WP 0018, Figure 213)
on reel-out solenoid (WP 0267).
Install right side debris guards (WP
0187).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 1885-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1885-03 is not active.
Code 1885-03 Not Active - Trouble-
shooting complete.
Test Step 4. Test F868-OR Reel-Out
Solenoid Supply Circuit for Short
to Other Voltage Source in Platform
Wiring Harness.
1. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
0023-107