TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-04 Winch Spool Out
5. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Voltage Below Nor-
0283), test for continuity between
Proceed to step 6.
mal - Continued
PL-C2 terminal 33 and all other
Continuity on One or More Test
circuits in PL-C2 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 215).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install front floor plate on machine
(WP 0205).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PL-C2 terminal 33 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install front floor plate on machine
(WP 0205).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
0023-113
