TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-04 Winch Spool Out
9. Using MSD (WP 0016), select
Code 1885-04 Active - Repeat trou-
Solenoid Voltage Below Nor-
machine control D6K ECM and
bleshooting code from the beginning.
mal - Continued
verify 1885-04 is not active.
Code 1885-04 Not Active - Trouble-
shooting complete.
N OT E
1885-05 Winch Spool Out
Solenoid Current Below Nor-
Always inspect harness connectors thatare involved in the circuit. Poor
mal
connections can often be the cause of an electrical circuit problem. Ver-
ify that all connections in circuit are clean and secure, and connections
are in good condition. If problem with connection is found, correct the
problem and verify diagnostic code is active before performing this pro-
cedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
Test Step 1. Test for Open Reel-Out
Solenoid.
1. Connect MSD (WP 0016). Select
machine control D6K ECM and
verify 1885-05 is active.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Remove rear bottom guards from
machine (WP 0156).
4. Disconnect pump wiring harness
connector PH-C9 from reel-out
solenoid (WP 0018, Figure 213)
(WP 0267).
5. Connect jumper wire between
PH-C9 terminal 1 and terminal 2
(WP 0018, Figure 213).
6. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).