TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2268-05 Winch Free-Spool
Test Step 3. Test F870-BU Free
Solenoid Current Below Nor- Spool Solenoid Supply Circuit for
mal - Continued
High Resistance or Open in Plat-
form Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove jumper wire from PL-C33
terminal 1 and terminal 2 (WP
0018, Figure 233).
3. Disconnect platform wiring har-
ness connector PL-C2 (WP 0018,
Figure 215) from equipment ECM
(WP 0148).
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Proceed to Test Step 4.
between PL-C2 terminal 34 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 215) and PL-C33
Replace platform wiring harness (WP
terminal 2 (WP 0018, Figure 233).
0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 2268-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2268-05 is not active.
Code 2268-05 Not Active - Trouble-
shooting complete.
0023-218