TM 5-2410-240-23-2
0060
CLEANING AND INSPECTION
00060
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK
OIL TUBE INSTALLATION
00060
N OT E
Remove caps and install tubes and wiring harness as noted during removal.
Do not tighten until each nut and bolt is installed.
1. Install new washer (Figure 5, Item 5), tube (Figure 5, Item 3), new washer (Figure 5, Item 6), and fluid passage
bolt (Figure 5, Item 4) finger tight on machine.
2. Install tube nut (Figure 5, Item 2) on fuel injection pump (Figure 5, Item 1) finger tight.
3. Torque tube nut (Figure 5, Item 2) and fluid passage bolt (Figure 5, Item 4) to 11 lb-ft (15 Nm).
4. Connect harness connector (Figure 5, Item 7) on machine.
5. Install primary fuel filter (WP 0074).
END OF TASK
0060-9