TM 5-2410-240-23-2
0082
REMOVAL CONTINUED
2. Remove two bolts (Figure 2, Item 1) and water temperature regulator housing (Figure 2, Item 2) from cylinder
head (Figure 2, Item 3).
Figure 2. Water Temperature Regulator Housing.
0082
3. Remove O-ring (Figure 3, Item 2) and water temperature regulator (Figure 3, Item 3) from water temperature
regulator housing (Figure 3, Item 1). Discard O-ring and water temperature regulator.
Figure 3. Water Temperature Regulator.
0082
END OF TASK
CLEANING AND INSPECTION
00082
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK
INSTALLATION
00082
1. Position new O-ring seal (Figure 3, Item 2) and new water temperature regulator (Figure 3, Item 3) on water
temperature regulator housing (Figure 3, Item 1).
2. Install water temperature regulator housing (Figure 2, Item 2) and two bolts (Figure 2, Item 1) on cylinder head
(Figure 2, Item 3). Tighten bolts to 32.5 lb-ft (44 Nm).