TM 5-2410-240-23-2
0133
INSTALLATION
000133
N OT E
Note position of bolts, clips, spacers and bracket to aid installation.
1. Install bracket (Figure 15, Item 2), spacer (Figure 15, Item 4), three clips (Figure 15, Item 5), four washers
(Figure 15, Item 1), and bolts (Figure 15, Item 3) on housing (Figure 15, Item 6).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
N OT E
Pump weighs approximately 158 lb (72 kg).
Install housing as noted during removal.
2. Attach lifting device to housing (Figure 16, Item 1) and pump (Figure 16, Item 2).
3. Install housing (Figure 16, Item 1), washers (Figure 16, Item 4), and four bolts (Figure 16, Item 3) on pump
(Figure 16, Item 2). Place pump and housing on flat level surface and remove lifting device.
Figure 16. Pump and Housing.
0133