TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1401-5 Transmission Sole-
10. Turn ignition switch and battery
noid Valve #1 Voltage
disconnect switch to OFF position
Below Normal - Contin-
(TM 5-2410-241-10).
ued
11. Remove jumper wire between pins
1 and 2 on transmission solenoid
valve #1 connector P-C4 (WP
0018, Figure 71).
12. Remove left platform access panel
(WP 0207).
13. Disconnect steering control har-
ness connector X-C1 (WP 0018,
Figure 34) from platform harness
connector MA-C14 (WP 0018,
Figure 33).
14. Disconnect powertrain ECM con-
nector X-C2 (WP 0018, Figure 4)
from powertrain ECM.
15. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 16.
pin 65 on powertrain ECM connec- 2.
If continuity is NOT found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
pin 28 on steering control harness
0178). Ensure all harness connec-
connector X-C1 (WP 0018,
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
16. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 17.
pin 55 on powertrain ECM connec- 2.
If continuity is NOT found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
pin 30 on steering control harness
0178). Ensure all harness connec-
connector X-C1 (WP 0018,
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
17. Remove rear floor plate (WP
0231).
18. Disconnect platform harness con-
nector MA-C7 (WP 0018, Figure
53) from transmission jumper har-
ness connector MP-C2 (WP 0018,
Figure 54).
0020-160