TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1401-6 Transmission Sole-
10. Remove left platform access panel
noid Valve #1 Current
(WP 0207).
Above Normal - Contin-
ued
11. Disconnect steering control har-
ness connector X-C1 (WP 0018,
Figure 34) from platform harness
connector MA-C14 (WP 0018,
Figure 33).
12. Disconnect powertrain ECM con-
nector X-C3 (WP 0018, Figure 3)
from powertrain ECM.
13. Disconnect powertrain ECM con-
nector X-C2 (WP 0018, Figure 4)
from powertrain ECM.
14. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 15.
pin 65 on powertrain ECM connec- 2.
If continuity is NOT found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
pin 28 on steering control harness
0178). Ensure all harness connec-
connector X-C1 (WP 0018,
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
15. Using a digital multimeter (WP
1.
If continuity is found, proceed to
0296), test for continuity between
step 16.
pin 55 on powertrain ECM connec- 2.
If continuity is NOT found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
pin 30 on steering control harness
0178). Ensure all harness connec-
connector X-C1 (WP 0018,
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
16. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 17.
pin 65 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
all other pins in powertrain ECM
0178). Ensure all harness connec-
connector X-C2 (WP 0018,
tors are reconnected. Verify cor-
Figure 4).
rect operation of machine (TM 5-
2410-241-10).
17. Using a digital multimeter (WP
1.
If continuity is NOT found, proceed
0296), test for continuity between
to step 18.
pin 65 on powertrain ECM connec- 2.
If continuity is found, replace
tor X-C2 (WP 0018, Figure 4) and
steering control harness (WP
all other pins in powertrain ECM
0178). Ensure all harness connec-
connector X-C3 (WP 0018,
tors are reconnected. Verify cor-
Figure 3).
rect operation of machine (TM 5-
2410-241-10).
0020-164
