TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1405-6 Transmission Sole-
29. Using a digital multimeter (WP
1.
If continuity is found, replace pow-
noid Valve #5 Current
0296), test for continuity between
ertrain ECM (WP 0175). Ensure all
Above Normal - Contin-
pin I on transmission harness con-
harness connectors are recon-
ued
nector P-C1 (WP 0018, Figure 56)
nected. Verify correct operation of
all other pins in transmission har-
machine (TM 5-2410-241-10).
ness connector P-C1 (WP 0018,
2.
If continuity is NOT found, replace
Figure 56).
transmission sensor harness (WP
0173). Ensure all harness connec-
tors are reconnected. Verify cor-
rect operation of machine (TM 5-
2410-241-10).
1405-13 Transmission Sole-
1. Connect MSD (WP 0016), select
1. If active 1405-13 code is present,
noid Valve #5 Out of Cali-
Powertrain D7 ECM, and check for
proceed to step 2.
bration
Diagnostic Codes or Event Codes
2. If no active codes are present, the
problem does NOT exist at this
time. Resume normal operation.
2. Select Powertrain D7 ECM on the
left side of screen.
3. Select Service (Figure 79, Item 1),
Calibrations (Figure 79, Item 2),
Transmission Fill Calibration (Fig-
ure 79, Item 3).
Figure 79. ECM Selection.
0020