TM 5-2410-241-23-1
0039
Table 1. Preventive Maintenance Checks and Services (PMCS) - Continued.
LOCATION
ITEM TO
CHECK/
ITEM
NOT FULLY MISSION
SERVICE
NO.
INTERVAL
PROCEDURE
CAPABLE IF:
23
2,000 Hours
WARN I N G
Final Drive Oil -
or Annually
Change
Oil should be warm toensure it drains completely from final drive
assembly. Use caution to protect against burns when draining oil.
Contact with oil can damage skin. Wear gloves when handling
oil. If oil contacts skin, wash it off immediately.
Lubricating oil is very slippey. Immediately wipe up any spills.
r
Failure to follow these warnings may cause injury or death to per-
sonnel.
a. Position one final drive so oil level
Final drive oil level low.
mark (Figure 9, Item 1) is horizontal.
Drain plug (Figure 9, Item 3) will be
positioned at bottom of final drive.
b. Remove drain plug (Figure 9, Item
3) and O-ring. Allow oil to drain into a
suitable container. Discard
O-ring.
c. Replace O-ring.
d. Install drain plug (Figure 9, Item 3)
and new O-ring.
e. Remove oil fill plug (Figure 9, Item
2) and O-ring. Discard O-ring.
0039-21