TM 5-2410-241-23-2
0094
CLEANING AND INSPECTION
00094
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0295).
END OF TASK
INSTALLATION
00094
C AU T I O N
Do not disconnect jumper harness from sensor. Sensor damage will occur.
1. Do not disconnect connector (Figure 1, Item 3) from engine crankshaft position sensor (Figure 1, Item 1).
2. Install new O-ring (Figure 1, Item 2) on engine crankshaft position sensor (Figure 1, Item 1).
3. Install engine crankshaft position sensor (Figure 1, Item 2), clamp (Figure 1, Item 6), washer (Figure 1, Item 4)
and bolt (Figure 1, Item 5) on engine (Figure 1, Item 13).
4. Install clamp (Figure 1, Item 9) washer (Figure 1, Item 7) and bolt (Figure 1, Item 8) from engine (Figure 1, Item
13).
N OT E
Install electrical connectors as tagged during removal.
5. Connect connector (Figure 1, Item 10) and install new tiedown strap (Figure 1, Item 11) on harness (Figure 1,
Item 12).
END OF TASK
FOLLOW-ON TASKS
00094
1. Install front bottom guards (WP 0199).
2. Verify correct operation of machine (TM 5-2410-241-10).
END OF TASK
END OF WORK PACKAGE
0094-3/(4 blank)