TM 5-2410-241-23-2
0134
REMOVAL CONTINUED
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap all component connections during removal to protect against contamination. Failure
to follow this caution may cause damage to equipment.
N OT E
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid
IAW local policy and ordinances. Ensure all spills are cleaned up.
2. Install two bolts (Figure 2, Item 2) at locations (Figure 2, Item 3) to remove both inner and outer guides
(Figure 2, Item 1) from track frame (Figure 2, Item 4).
3. Remove two bolts (Figure 2, Item 2) from guides (Figure 2, Item 1) as guides are removed.
Figure 2. Forcing Screws.
0134
