6
TM 5-2410-241-23-2
FIELD MAINTENANCE INSTRUCTIONS
-
PIVOT SHAFT LUBRICATION LINE REPLACEMENT
0
158
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Tools and Special Tools
Materials/Parts - Continued
0
0
Tool Kit, General Mechanic's
Tag, Marker (WP 0303, Item 34)
0
(WP 0302, Item 65)
O-ring (5)
0
0
Gloves, Rubber (S0208)
References
(WP 0302, Item 68)
0
0
LO 5-2410-241-13
Pan, Drain (S0255)
0
WP 0295
(WP 0302, Item 68)
0
0
Wrench, Combination 1 3/8" (S0791)
Equipment Condition
0
(WP 0302, Item 68)
0
Machine parked (TM 5-2410-241-10)
0
Materials/Parts
Rear bottom guards removed (WP 0199)
0
0
Cap Set, Protective (WP 0303, Item 4)
Washer bottle removed (WP 0224)
0
0
Oil, Lubricating OEA, Arctic
Drawing Required
(WP 0303, Item 17)
0
0
TM 5-2410-241-24P, Figure 90
Oil, Lubricating OE/HDO 15/40
0
(WP 0303, Item 21)
0
Estimated Time to Complete
0
Oil, Lubricating OE/HDO-30
3.5 Hr
(WP 0303, Item 19)
0
0
Rag, Wiping (WP 0303, Item 24)
0
REMOVAL
000158
WARN I N G
Contact with oil can damage skin. Wear gloveswhen handling oil. If oil contacts skin, wash
it off immediately. Failure to follow this warning may cause injury to personnel.
Lubricating oil is very slippery. Immediaely wipe up any spills. Failure to follow this
t
warning may cause injury.
N OT E
Care must be taken to ensure that fluids ae contained during performance of inspection,
r
maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid
with suitable containers before opening any compartment or disassembling any
component containing fluids.
Dispose of all fluids accordingto local regulations and mandates.
Perform disassembly on a clean surface.
Clean exterior of component to prevent contamination.
Cap and plug all lines, hoses and tubesto prevent contamination and leaks.
Tag and mark all hoses and lines to aid installation.
0158-1
