TM 5-2410-241-23-2
0158
CLEANING AND INSPECTION
000158
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0295).
END OF TASK
INSTALLATION
000158
WARN I N G
Contact with oil can damage skin. Wear gloves when handling oil. If oil contacts skin,
wash it off immediately. Failure to follow this warning may cause injury to personnel.
Lubricating oil is very slippery. Immediaely wipe up any spills. Failure to follow this
t
warning may cause injury.
N OT E
Care must be taken to ensure that fluids ae contained during performance of inspection,
r
maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid
with suitable containers before opening any compartment or disassembling any
component containing fluids.
Remove plugs and caps from all lines, hoses and tubes.
Install hoses and lines as noted during removal.
1. Install two new O-rings (Figure 3, Item 7) and elbow fitting (Figure 3, Item 6) on pivot shaft housing (Figure 3,
Item 8).
2. Install line (Figure 3, Item 1) on machine.
3. Install line (Figure 3, Item 1) and tighten tube nut (Figure 3, Item 5) on fitting (Figure 3, Item 6).
N OT E
Install clamps and line as noted during removal.
4. Install four clamps (Figure 3, Item 4), washers (Figure 3, Item 3), and bolts (Figure 3, Item 2) on line (Figure 3,
Item 1).
0158-5
