18
TM 5-2410-241-23-3
FIELD MAINTENANCE
-
TILT CYLINDER LINES REPLACEMENT
0198
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Equipment Condition - Continued
Tools and Special Tools
0
0
Tool Kit, General Mechanic's
Hydraulic system pressure released
(WP 0302, Item 65)
(WP 0186)
0
0
Gloves, Rubber (S0208)
Engine enclosure right door guard removed
(WP 0302, Item 68)
0
0
Goggles (S0209)
Front floor plate removed (WP 0230)
0
(WP 0302, Item 68)
Cab seat removed (WP 0247)
0
0
Fire extinguisher and bracket removed
Materials/Parts
0
0
Cap Set, Protective (WP 0303, Item 4)
0
Hydraulic system drained (WP 0184)
0
Rag, Wiping (WP 0303, Item 24)
0
Front bottom guards removed (WP 0199)
0
Tag, Marker (WP 0303, Item 34)
0
Drawing Required
O-ring (4)
0
0
TM 5-2410-241-24P, Figure 83
References
0
0
Estimated Time to Complete
0
0
8.5 Hr
Equipment Condition
0
0
Machine parked (TM 5-2410-241-10)
0
REMOVAL
000198
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap all hydraulic hose and tube ends along with component connections during removal
to protect against contamination. Failure to follow this caution may cause damage to
equipment.
0198-1