TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0168-02 Electrical System
15. Using digital multimeter (WP
Continuity - Proceed to step 16.
Voltage Data Erratic, Inter-
0283), test for continuity between
No Continuity - Replace platform wir-
mittent, or Incorrect - Con-
pin 47 on platform harness ECM
ing harness (WP 0150, WP 0155).
tinued
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 8 on platform
reconnected. Verify proper operation
harness to fuse panel harness
of machine (TM 5-2410-240-10).
connector PL-C3 (WP 0018, Fig-
ure 216).
16. Using digital multimeter (WP
Continuity - Proceed to step 17.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 13 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and ground.
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
17. Using digital multimeter (WP
Continuity - Proceed to step 18.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 23 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and ground.
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
18. Using digital multimeter (WP
Continuity - Replace machine ECM
0283), test for continuity between
(WP 0147, WP 0149). Ensure all har-
pin 57 on platform harness ECM
ness connectors are reconnected.
J1 connector PL-C4 (WP 0018,
Verify proper operation of machine
Figure 217) and ground.
(TM 5-2410-240-10).
No Continuity - Replace platform wir-
ing harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
0168-03 Electrical System
Voltage Above Normal
Always inspect harness connectors that are involved in circuit. Poor
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0168-03 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Inspect charging system (WP
Verify proper operation of machine
(TM 5-2410-240-10).