TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0148-04 Hystat Drive Pres-
10. Disconnect platform harness
sure Sensor Voltage Below
ECM J1 connector PL-C4 (WP
Normal - Continued
0018, Figure 217) from machine
ECM (WP 0147, WP 0149).
11. Using digital multimeter (WP
Continuity - Proceed to step 12.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 21 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 22 on plat-
reconnected. Verify proper operation
form harness to chassis harness
of machine (TM 5-2410-240-10).
connector PL-C18 (WP 0018, Fig-
ure 226).
12. Using digital multimeter (WP
Continuity - Proceed to step 13.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 37 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 25 on plat-
reconnected. Verify proper operation
form harness to chassis harness
of machine (TM 5-2410-240-10).
connector PL-C18 (WP 0018, Fig-
ure 226).
13. Using digital multimeter (WP
No Continuity - Replace machine
0283), test for continuity between
ECM (WP 0147, WP 0149). Ensure all
pin 37 on platform harness ECM
harness connectors are reconnected.
J1 connector PL-C4 (WP 0018,
Verify proper operation of machine
Figure 217) and all other pins on
(TM 5-2410-240-10).
platform harness ECM J1 connec-
Continuity - Replace platform wiring
tor PL-C4 (WP 0018, Figure 217).
harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
Perform Hydrostatic Pump and Motor
Travel pressure sensor requires cali-
0148-13 Hystat Drive Pres-
Solenoid Calibration (WP 0030).
bration.
sure Sensor out of Calibra-
tion
N OT E
0168-02 Electrical System
Voltage Data Erratic, Inter-
Always inspect the harness connectorsthat are involved in the circuit.
mittent, or Incorrect
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean, secure and
that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0168-02 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.