TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
N OT E
0168-04 Electrical System
Voltage Below Normal
Always inspect harness connectors that are involved in circuit. Poor
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0168-04 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Inspect charging system (WP
Verify proper operation of machine
(TM 5-2410-240-10).
N OT E
0190-02 Engine Speed Sen-
sor Data Erratic, Intermit-
Always inspect harness connectors that are involved in circuit. Poor
tent, or Incorrect
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0190-02 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. The engine speed (flywheel) sen-
Sensor Adjusted Correctly - Pro-
sor is an adjustable sensor. Verify
ceed to step 4.
sensor is correctly adjusted (WP
Sensor Not Adjusted Correctly -
0058).
Adjust sensor, start the engine, and
verify proper operation of machine
(TM 5-2410-240-10).
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).