TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0444-05 Starter Motor Relay
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
Current Below Normal -
0283), test for continuity between
No Continuity - Replace engine wir-
Continued
pin 1 on engine harness starter
ing harness assembly (WP 0046).
motor connector EN-C2 (WP
Ensure all harness connectors are
0018, Figure 124) and pin 28 on
reconnected. Verify proper operation
engine harness to platform har-
of machine (TM 5-2410-240-10).
ness connector EN-C15 (WP
0018, Figure 132).
9. Using digital multimeter (WP
Continuity - Proceed to step 10.
0283), test for continuity between
No Continuity - Replace engine wir-
pin 2 on engine harness starter
ing harness assembly (WP 0046).
motor connector EN-C2 (WP
Ensure all harness connectors are
0018, Figure 124) and pin 29 on
reconnected. Verify proper operation
engine harness to platform har-
of machine (TM 5-2410-240-10).
ness connector EN-C15 (WP
0018, Figure 132).
10. Using digital multimeter (WP
No Continuity - Proceed to step 11.
0283), test for continuity between
Continuity - Replace engine wiring
pin 28 on engine harness to plat-
harness assembly (WP 0046). Ensure
form harness connector EN-C15
all harness connectors are recon-
(WP 0018, Figure 132) and all
nected. Verify proper operation of
other pins on engine harness to
machine (TM 5-2410-240-10).
platform harness connector EN-
C15 (WP 0018, Figure 132).
11. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from machine
ECM (WP 0147, WP 0149).
12. Using digital multimeter (WP
Continuity - Proceed to step 13.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 28 on platform harness to
ing harness (WP 0150, WP 0155).
engine harness connector PL-
Ensure all harness connectors are
C15 (WP 0018, Figure 225) and
reconnected. Verify proper operation
pin 7 on platform harness ECM J2
of machine (TM 5-2410-240-10).
connector PL-C5 (WP 0018, Fig-
ure 218).
13. Using digital multimeter (WP
Continuity - Proceed to step 14.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 29 on platform harness to
ing harness (WP 0150, WP 0155).
engine harness connector PL-
Ensure all harness connectors are
C15 (WP 0018, Figure 225) and
reconnected. Verify proper operation
pin 8 on platform harness ECM J2
of machine (TM 5-2410-240-10).
connector PL-C5 (WP 0018, Fig-
ure 218).
0020-54