TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0444-06 Starter Motor Relay
4. Check for diagnostic codes (WP
0444-06 Code Active - Proceed to
Current Above Normal -
step 5.
Continued
0444-05 Code Active - Replace
starter motor (WP 0095). Ensure all
harness connectors are reconnected.
Verify proper operation of machine
(TM 5-2410-240-10).
5. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
6. Disconnect platform harness to
engine harness connector PL-
C15 (WP 0018, Figure 225) from
engine harness to platform har-
ness connector EN-C15 (WP
0018, Figure 132).
7. Using digital multimeter (WP
Continuity - Proceed to step 8.
0283), test for continuity between
No Continuity - Replace engine wir-
pin 1 on engine harness starter
ing harness assembly (WP 0046).
motor connector EN-C2 (WP
Ensure all harness connectors are
0018, Figure 124) and pin 28 on
reconnected. Verify proper operation
engine harness to platform har-
of machine (TM 5-2410-240-10).
ness connector EN-C15 (WP
0018, Figure 132).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace engine wir-
pin 2 on engine harness starter
ing harness assembly (WP 0046).
motor connector EN-C2 (WP
Ensure all harness connectors are
0018, Figure 124) and pin 29 on
reconnected. Verify proper operation
engine harness to platform har-
of machine (TM 5-2410-240-10).
ness connector EN-C15 (WP
0018, Figure 132).
9. Using digital multimeter (WP
No Continuity - Proceed to step 10.
0283), test for continuity between
Continuity - Replace engine wiring
pin 28 on engine harness to plat-
harness assembly (WP 0046). Ensure
form harness connector EN-C15
all harness connectors are recon-
(WP 0018, Figure 132) and all
nected. Verify proper operation of
other pins on engine harness to
machine (TM 5-2410-240-10).
platform harness connector EN-
C15 (WP 0018, Figure 132).
10. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from Machine
ECM (WP 0147, WP 0149).
0020-56