TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0600-03 Hydraulic Oil Temp
7. Using digital multimeter (WP
Continuity - Proceed to step 8.
Sensor Voltage Above Nor-
0283), test for continuity between
No Continuity - Replace chassis har-
mal - Continued
pin 30 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 1
Verify proper operation of machine
on chassis harness hydraulic tem-
(TM 5-2410-240-10).
perature sender connector CH-
C13 (WP 0018, Figure 89).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 22 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 2
Verify proper operation of machine
on chassis harness hydraulic tem-
(TM 5-2410-240-10).
perature sender connector CH-
C13 (WP 0018, Figure 89).
9. Disconnect platform harness
ECM J1 connector PL-C4 (WP
0018, Figure 217) from machine
ECM (WP 0147, WP 0149).
10. Using digital multimeter (WP
Continuity - Proceed to step 11.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 30 on platform harness to
ing harness (WP 0150, WP 0155).
chassis harness connector PL-
Ensure all harness connectors are
C18 (WP 0018, Figure 226) and
reconnected. Verify proper operation
pin 22 on platform harness ECM
of machine (TM 5-2410-240-10).
J1 connector PL-C4 (WP 0018,
Figure 217).
11. Using digital multimeter (WP
Continuity - Replace machine ECM
0283), test for continuity between
(WP 0147, WP 0149). Ensure all har-
pin 22 on platform harness to
ness connectors are reconnected.
chassis harness connector PL-
Verify proper operation of machine
C18 (WP 0018, Figure 226) and
(TM 5-2410-240-10).
pin 21 on platform harness ECM
No Continuity - Replace platform wir-
J1 connector PL-C4 (WP 0018,
ing harness (WP 0150, WP 0155).
Figure 217).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
0020-59