TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
N OT E
0600-04 Hydraulic Oil Temp
Sensor Voltage Below Nor-
Always inspect harness connectors that are involved in circuit. Poor
mal
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure and connections
are in good condition. If a problem with a connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
0600-04 Code Active - Proceed to
1. Connect MSD (WP 0016). Select
step 2.
machine control ECM and check
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect chassis harness
hydraulic temperature sender
connector CH-C13 (WP 0018,
Figure 89) from hydraulic temper-
ature sender (WP 0178).
4. Check for diagnostic codes (WP
0600-04 Code Active - Proceed to
step 5.
0600-03 Code Active - Replace
hydraulic temperature sensor (WP
0178). Ensure all harness connectors
are reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-10).
5. Disconnect chassis harness to
platform harness connector CH-
C1 (WP 0018, Figure 81) from
platform harness to chassis har-
ness connector PL-C18 (WP
0018, Figure 226).
6. Using digital multimeter (WP
Continuity - Proceed to step 7.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 30 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 1
Verify proper operation of machine
on chassis harness hydraulic tem-
(TM 5-2410-240-10).
perature sender connector CH-
C13 (WP 0018, Figure 89).