TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1326-02 ECM Location Code
3. Check MSD (WP 0016) and verify
Location Codes Correct - Replace
Data Erratic, Intermittent, or
location code is correct.
machine ECM (WP 0147, WP 0149).
Incorrect - Continued
Verify proper operation of machine
(TM 5-2410-240-10).
Location Codes Not Correct -
Repeat step 2 in order to verify that
software and hardware part numbers
are correct, then replace machine
ECM (WP 0147, WP 0149). Verify
proper operation of machine (TM 5-
2410-240-10).
N OT E
1482-03 Sensor Power Sup-
ply (10 VDC) Voltage Above
Always inspect harness connectors that are involved in circuit. Poor
Normal
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure and connections
are in good condition. If a problem with connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
1482-03 Code Active - Proceed to
1. Connect MSD (WP 0016). Select
step 2.
machine control ECM and check
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect seat harness steering
and transmission control handle
base connector CA-C5 (WP 0018,
Figure 71) from left joystick con-
trol (WP 0239).
4. Disconnect seat harness steering
and transmission control handle
connector CA-C6 (WP 0018, Fig-
ure 72) from left joystick control
(WP 0239).
5. Disconnect seat harness blade
control handle connector CA-C7
(WP 0018, Figure 73) from right
joystick control (WP 0240).
6. Disconnect seat harness blade
control handle connector CA-C8
(WP 0018, Figure 74) from right
joystick control (WP 0240).