TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1482-03 Sensor Power Sup-
27. Remove rear bottom guard
ply (10 VDC) Voltage Above
(WP 0157).
Normal - Continued
28. Disconnect winch solenoid har-
ness connector WC-C4 (WP
0018, Figure 251) from winch oil
pressure sensor.
29. Using digital multimeter (WP
No Continuity - Replace machine
0283), test for continuity between
ECM (WP 0147, WP 0149). Ensure all
pin 9 on winch solenoid harness
harness connectors are reconnected.
connector WC-C2 (WP 0018, Fig-
Verify proper operation of machine
ure 249) and all other pins on
(TM 5-2410-240-10).
winch solenoid harness connector
Continuity - Replace winch solenoid
WC-C2 (WP 0018, Figure 249).
harness (WP 0138). Ensure all har-
ness connectors are reconnected.
Verify proper operation of machine
(TM 5-2410-240-10).
N OT E
1482-04 Sensor Power Sup-
ply (10 VDC) Voltage Below
Always inspect harness connectors th t are involved in circuit. Poor
a
Normal
connections can often be the cause of an electrical circuit problem. Ver-
ify that all connections in circuit are clean, secure and connections are
in good condition. If a problem with connection is found, correct problem
and verify diagnostic code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
1482-04 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect seat harness to cab
harness connector CA-C1 (WP
0018, Figure 69) from cab har-
ness to seat harness connector
C-C24 (WP 0018, Figure 26).
4. Check for diagnostic codes (WP
1482-04 Code Active - Proceed to
step 18.
1482-04 Code Not Active - Proceed
to step 5.
5. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).