TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1482-04 Sensor Power Sup-
24. Turn ignition switch and battery
ply (10 VDC) Voltage Below
disconnect switch to OFF position
Normal - Continued
(TM 5-2410-240-10).
25. Reconnect platform harness con-
nector PL-C33 (WP 0018, Figure
233) on winch solenoid harness
connector WC-C2 (WP 0018, Fig-
ure 249).
26. Remove rear bottom guard (WP
0157).
27. Disconnect winch solenoid har-
ness connector WC-C4 (WP
0018, Figure 251) from winch oil
pressure sensor.
28. Check for diagnostic codes (WP
1482-04 Code Active - Replace
winch solenoid harness (WP 0138).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
1482-04 Code Not Active - Replace
winch oil pressure sensor (WP 0137).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
29. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
30. Disconnect platform harness to
cab harness connector PL-C1
(WP 0018, Figure 214) from cab
harness to platform harness con-
nector C-C12 (WP 0018, Figure
22).
31. Using digital multimeter (WP
No Continuity - Proceed to step 32.
0283), test for continuity between
Continuity - Replace cab harness
pin 45 on cab harness to platform
(WP 0233, WP 0234). Ensure all har-
harness connector C-C12 (WP
ness connectors are reconnected.
0018, Figure 22) and all other
Verify proper operation of machine
pins on cab harness to platform
(TM 5-2410-240-10).
harness connector C-C12 (WP
0018, Figure 22).
0020-78