TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1482-04 Sensor Power Sup-
39. Using digital multimeter (WP
No Continuity - Replace machine
ply (10 VDC) Voltage Below
0283), test for continuity between
ECM (WP 0147). Ensure all harness
Normal - Continued
pin 69 on platform harness ECM
connectors are reconnected. Verify
J1 connector PL-C4 (WP 0018,
proper operation of machine (TM 5-
Figure 217) and all pins on plat-
2410-240-10).
form harness connector PL-C2
Continuity - Replace platform wiring
(WP 0018, Figure 215).
harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
1703-03 Proportional Sole-
noid Valve (Forward Left
Always inspect harness connectors that are involved in circuit. Poor
Drive Pump) Voltage Above
connections can often be the cause of an electrical circuit problem.
Normal
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.
1703-03 Code Active - Proceed to
1. Connect MSD (WP 0016). Select
step 2.
machine control ECM and check
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect pump harness LH for-
ward pump solenoid connector
PH-C7 (WP 0018, Figure 211)
from LH forward pump solenoid.
4. Disconnect pump harness to
engine harness connector PH-C1
(WP 0018, Figure 205) from
engine harness to platform har-
ness connector EN-C21 (WP
0018, Figure 137).
5. Using digital multimeter (WP
Continuity - Proceed to step 6.
0283), test for continuity between
No Continuity - Replace pump har-
pin 11 on pump harness to engine
ness (WP 0046). Ensure all harness
harness connector PH-C1 (WP
connectors are reconnected. Verify
0018, Figure 205) and pin 1 on
proper operation of machine (TM 5-
pump harness LH forward pump
2410-240-10).
solenoid connector PH-C7 (WP
0018, Figure 211).