TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1482-03 Sensor Power Sup-
7. Disconnect seat harness to cab
ply (10 VDC) Voltage Above
harness connector CA-C1 (WP
Normal - Continued
0018, Figure 69) from cab har-
ness to seat harness connector
C-C24 (WP 0018, Figure 26).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace seat wiring
pin 2 on seat harness to cab har-
harness (WP 0236). Ensure all har-
ness connector CA-C1 (WP 0018,
ness connectors are reconnected.
Figure 69) and pin 1 on seat har-
Verify proper operation of machine
ness steering and transmission
(TM 5-2410-240-10).
control handle base connector
CA-C5 (WP 0018, Figure 71).
9. Using digital multimeter (WP
Continuity - Proceed to step 10.
0283), test for continuity between
No Continuity - Replace seat wiring
pin 2 on seat harness to cab har-
harness (WP 0236). Ensure all har-
ness connector CA-C1 (WP 0018,
ness connectors are reconnected.
Figure 69) and pin 1 on seat har-
Verify proper operation of machine
ness steering and transmission
(TM 5-2410-240-10).
control handle connector CA-C6
(WP 0018, Figure 72).
10. Using digital multimeter (WP
Continuity - Proceed to step 11.
0283), test for continuity between
No Continuity - Replace seat wiring
pin 2 on seat harness to cab har-
harness (WP 0236). Ensure all har-
ness connector CA-C1 (WP 0018,
ness connectors are reconnected.
Figure 69) to pin 1 on seat har-
Verify proper operation of machine
ness blade control handle con-
(TM 5-2410-240-10).
nector CA-C7 (WP 0018, Figure
73).
11. Using digital multimeter (WP
Continuity - Proceed to step 12.
0283), test for continuity between
No Continuity - Replace seat wiring
pin 2 on seat harness to cab har-
harness (WP 0236). Ensure all har-
ness connector CA-C1 (WP 0018,
ness connectors are reconnected.
Figure 69) and pin 1 on seat har-
Verify proper operation of machine
ness blade control handle base
(TM 5-2410-240-10).
connector CA-C8 (WP 0018, Fig-
ure 74).
12. Using digital multimeter (WP
No Continuity - Proceed to step 13.
0283), test for continuity between
Continuity - Replace seat wiring har-
pin 2 on seat harness to cab har-
ness (WP 0236). Ensure all harness
ness connector CA-C1 (WP 0018,
connectors are reconnected. Verify
Figure 69) and all other pins on
proper operation of machine (TM 5-
seat harness to cab harness con-
2410-240-10).
nector CA-C1 (WP 0018, Figure
69).
0020-72