TM 5-2410-240-23-1
0022
Table 1. Window Wiper and Washer Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Left Door Wiper Does
8. Using digital multimeter, test for
No Continuity - Replace platform
Not Operate Properly
continuity (WP 0283) between left
harness (WP 0150, WP 0155).
Continued
door wiper/washer switch harness
Ensure all harness connectors are
connector C-C6 (WP 0018, Figure
reconnected. Verify proper operation
18) terminal 1 and harness con-
of machine (TM 5-2410-240-10).
nector C-C12 (WP 0018, Figure
Continuity - Replace left door wiper/
22) terminal 22.
washer switch (WP 0212). Ensure all
harness connectors are reconnected.
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 5.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Inspect fuse #26 (TM 5-2410-240- Fuse #26 OK - Proceed to step 3.
10).
Fuse #26 Not OK - Proceed to Test
Step 6.
3. Disconnect left door washer pump
harness connector WP-C5 (WP
0018, Figure 234) from rear win-
dow washer pump.
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
5. Turn left door wiper/washer con-
trol to wash position (TM 5-2410-
240-10).
6. Using digital multimeter, check for
Voltage Less Than Specified Range
voltage (WP 0283) between left
- Proceed to step 7.
door washer pump harness con-
Voltage Within Specified Range -
nector WP-C5 (WP 0018, Figure
Replace rear window washer pump
234) terminal 1 and 2.
(WP 0223). Ensure all harness con-
Voltage should be approximately 18 to
nectors are reconnected. Verify
26 volts.
proper operation of machine (TM 5-
2410-240-10).
7. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
8. Disconnect harness connector
WP-C1 (WP 0018, Figure 4) from
harness connector CH-C26 (WP
0018, Figure 97).
0022-34