TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-05 Winch Spool In
7. Check for active code 1884-05 or
Code 1884-05 Remains Active - Pro-
Solenoid Current Below Nor-
1884-06 in machine control D6K
ceed to Test Step 2.
mal - Continued
ECM (WP 0016).
Code 1884-05 Becomes Inactive
and 1884-06 Becomes Active - Turn
ignition switch and battery disconnect
switch to OFF position (TM 5-2410-
240-10).
Remove jumper wire from PH-C8 ter-
minal 1 and terminal 2 (WP 0018, Fig-
ure 212).
Replace reel-in solenoid (WP 0132).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 1884-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1884-05 is not active.
Code 1884-05 Not Active - Trouble-
shooting complete.
Test Step 2. Test for Open Pump
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove jumper wire from PH-C8
terminal 1 and terminal 2 (WP
0018, Figure 212).
3. Remove right side debris guards
from machine (WP 0187).
4. Disconnect pump wiring harness
connector PH-C1 (WP 0018, Fig-
ure 205) from engine wiring har-
ness connector EN-C21 (WP
0018, Figure 137) (WP 0046).
5. Connect jumper wire between
EN-C21 terminal 2 and terminal 6
(WP 0018, Figure 137).
6. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
0023-93