TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-05 Winch Spool In
Test Step 5. Test J807-BK Reel-In
Solenoid Current Below Nor- Solenoid Return Circuit for High
mal - Continued
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace equipment ECM (WP 0148).
between PL-C2 terminal 27 (WP
Connect platform wiring harness con-
0018, Figure 215) and PL-C32
nector PL-C5 (WP 0018, Figure 218)
terminal 3 (WP 0018, Figure 232).
on ECM J2 (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1 (WP 0149).
Connect engine wiring harness con-
nector EN-C50 (WP 0018, Figure
140) on platform wiring harness con-
nector PL-C32 (WP 0018, Figure 232)
(WP 0046).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C8 on reel-in solenoid (WP
0018, Figure 212) (WP 0267).
Install right side debris guards (WP
0187).
Install front floor plate (WP 0205).
Proceed to Test Step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness (WP
0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C8 on reel-in solenoid (WP
0018, Figure 212) (WP 0267).
Install right side debris guards on
machine (WP 0187).
Install front floor plate on machine
(WP 0205).
Proceed to step 2.
0023-97