TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-05 Winch Spool In
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
Solenoid Current Below Nor-
0283), measure resistance
Proceed to Test Step 5.
mal - Continued
between PL-C2 terminal 26 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 215) and PL-C32
Replace platform wiring harness (WP
terminal 2 (WP 0018, Figure 232).
0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C8 on reel-in solenoid (WP
0018, Figure 212) (WP 0267).
Install right side debris guards on
machine (WP 0187).
Install front floor plate on machine
(WP 0205).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 1884-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1884-05 is not active.
Code 1884-05 Not Active - Trouble-
shooting complete.
0023-96